Skip to content
Research Article Open access CC BY 4.0

Factors of Influence in the Results of 3D Measurements: Software Associated with Coordinate Measuring Machines

Charfadine Nimane Mahamat, Stéphane Raynaud, Youssouf Mandiang

Current Journal of Applied Science and Technology · pp. 1–8 · Published 2 May 2017

10.9734/BJAST/2017/33017

Abstract

In three-dimensional metrology, the means of 3D measurements have been widely multiplied in recent years, in metrology laboratories, in production workshops, with the evolution of technology in general, the software associated with these machines are multiplied and allow to obtain the results of measurements with different methods. In this article we carry virtual measurements on a part, using two different software associated with coordinate measuring machines, but without the CMM. To do this we use the same measurement procedure in these two software, the least-squares method is applied for the evaluation of the geometrical specifications of the part. The results obtained by the two programs are compared with the nominal values. The article highlights the hypothesis that the software contributes in the 3D measurement results; this approach allows the CMM measurement controller to know what measurement her software, before doing physical measurements on the CMM. 

Virtual measurements software CMM uncertainty 3D measuring means

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

16

Page views

0

PDF downloads

1

Outbound clicks

0

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.