Skip to content
Research Article Open access CC BY 3.0

Material Selection for Axial Spring in a Prototype Cam-Follower Mechanism

Kunle Joseph Akinluwade, G. E. Ogwu, O. T. Badamasi, A. T. Taiwo, A. R. Adetunji, O. O. Adewoye

Current Journal of Applied Science and Technology · pp. 3134–3142 · Published 7 Jun 2014

10.9734/BJAST/2014/10594

Abstract

A prototype cam-follower mechanism was designed and assembled using Pro-Engineer (Pro-E) software. The mechanism is meant for application in a forth-and-back Mode II Operation of a tribotester rig. The mechanism was dynamically simulated in Pro-E to ascertain the dynamic loading status of integral parts. CES EduPack software was applied to select the best material for the spring using the Function-Objectives-Constraints approach. Candidate materials were first screened using design constraints after which shortlisted materials were ranked using design objectives. The final material choice made with reasonable trade-offs was found suitable for intended service environment requirements.

Prototype material selection cam-follower spring dynamic simulation Pro-E objective constraint

References (3)

  1. 1 Materials Science and Engineering: An Introduction
  2. 2 Engineering design: A materials and processing approach [DOI]
  3. 3 Taguchi Technique for the Simultaneous Optimization of Tribological Parameters in Metal Matrix Composite [DOI]

Cited by 2

Material Selection for Crusher Jaw in a Jaw Crusher Equipment

A. Adetunji, A. Abioye, Dayo Adeyemi Isadare · 2015

Article metrics

Real usage data collected on this platform.

30

Page views

0

PDF downloads

11

Outbound clicks

2

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.